Steve36445
Well-known member
- Joined
- Dec 23, 2007
- Messages
- 58
- Programming Experience
- 10+
I’m in big trouble here and would be grateful for any help.
I have been working on a quite complex multiform solution.
All of a sudden the start up form (in fact any form I designate to start up) loads, displays and operates fine.
But when I try and show a form using “showdialog” the form displays behind the original form and I can’t set focus to the ide to close it down. I have to use task manager or alt f4 while the form has the focus.
Calling different forms from this one gives the same result but other forms work fine. I don’t want to redo this form as I’ve done a lot of work onit.
The only thing I can think of that whist I was changing the startup form in the project propertied page (file>project>properties) I unchecked the “Enable applications framework” checkbox.
This mucked up the display until I rechecked it, the trouble started around then.
Thanks,
Steve
I have been working on a quite complex multiform solution.
All of a sudden the start up form (in fact any form I designate to start up) loads, displays and operates fine.
But when I try and show a form using “showdialog” the form displays behind the original form and I can’t set focus to the ide to close it down. I have to use task manager or alt f4 while the form has the focus.
Calling different forms from this one gives the same result but other forms work fine. I don’t want to redo this form as I’ve done a lot of work onit.
The only thing I can think of that whist I was changing the startup form in the project propertied page (file>project>properties) I unchecked the “Enable applications framework” checkbox.
This mucked up the display until I rechecked it, the trouble started around then.
Thanks,
Steve