i have a OWI-007 robot arm, i also have the interface for it so i can plug it into the parallel port on the computer. i have been playing around with the programing for about 4 days yet and i still cannot figure out how to stop all power from going to the port.
i understand i have to use the inpout32.dll and create a module but i thought maybe that just using module1.out(888, 0) in the form1_load private sub would work but it is not, i try looping it but it freezes. any suggestions?
i have attached what i have so far
i understand i have to use the inpout32.dll and create a module but i thought maybe that just using module1.out(888, 0) in the form1_load private sub would work but it is not, i try looping it but it freezes. any suggestions?
i have attached what i have so far
Attachments
Last edited by a moderator:
